Cyclamatic Power Plus Electric E Bike Manual

How to Operate and Maintain Your Cyclamatic Power Plus Electric E Bike

If you are looking for a commuter and leisure bicycle that is easy to use, stylish and comfortable, you might want to consider the Cyclamatic Power Plus Electric E Bike. This e-bike features a 36V lithium-ion battery that can power the bike for up to 28 miles on normal terrain and reach speeds of up to 15 mph. It also has a quick release battery and front wheel, 21-speed Shimano gears, padded saddle, front suspension and Kenda tyres for a smooth ride.

However, before you hop on your e-bike and enjoy the ride, you need to know how to operate and maintain it properly. This article will guide you through the basic steps of using and caring for your Cyclamatic Power Plus Electric E Bike, based on the information from the official operating manual[^1^]. You can also download the manual from the link below for more details.

Download Cyclamatic Power Plus CX1 Operating Manual

How to Operate Your Cyclamatic Power Plus Electric E Bike

To operate your e-bike, you need to follow these steps:

Charge the battery. Plug the charger into a wall socket and connect it to the battery. The charger will show a red light when charging and a green light when fully charged. It takes about 4-6 hours to charge the battery fully. You can remove the battery from the bike by pulling back the quick release lever and sliding it out.

Turn on your e-bike. Insert the battery into the bike and lock it in place with the quick release lever. Press and hold the power button on the handlebar until the LCD display lights up. The display will show you the battery level, speed, distance and assist level.

Select an assist level. There are five levels of assist: 0 (no assist), 1 (low), 2 (medium), 3 (high) and 4 (max). You can change the level by pressing the up or down buttons on the handlebar. The higher the level, the more power the motor will provide when you pedal.

Pedal and brake. To start moving, pedal forward and use the brake levers to stop. The motor will automatically cut off when you brake or stop pedaling. You can also use the throttle on the right handlebar to accelerate without pedaling, but this will drain the battery faster.

Change gears. You can change gears by using the shifter levers on the handlebar. The left lever controls the front derailleur (three gears) and the right lever controls the rear derailleur (seven gears). Pushing or pulling the levers will move the chain to a higher or lower gear.

How to Maintain Your Cyclamatic Power Plus Electric E Bike

To maintain your e-bike, you need to follow these tips:

Keep your e-bike clean and dry. Wipe off any dirt or moisture with a soft cloth after each ride. Do not use a hose or pressure washer to clean your e-bike as this may damage the electrical components.

Check your tyres regularly. Make sure they are inflated to the recommended pressure (40-65 psi) and have no punctures or cracks. You can use a pump or a gauge to measure the pressure.

Lubricate your chain and gears periodically. Apply a thin layer of bike oil or grease to your chain and gears every few weeks or after riding in wet or dusty conditions. This will prevent rust and wear.

Adjust your brakes and derailleurs as needed. If your brakes are squeaking or not stopping well, you may need to tighten or loosen the brake cables or pads. If your gears are skipping or not shifting smoothly, you may need to adjust the derailleur cables or screws. You can find more instructions on how to do this in the manual or online videos.

Store your e-bike in a cool and dry place. Avoid exposing your e-bike to extreme temperatures or humidity as this may 061ffe29dd